The Fire Incidents Records Exchange (FIRE) Project started in 2002 and phase 7 of the project began in 2023 for a duration of three years, with 14 countries currently participating. The main purpose ...

The NEA Second Framework for Irradiation Experiments (FIDES-II) supports the fuel and material experimental needs of nuclear safety regulators, technical support organisations, research institutions ...

RASPLAV-A-Salt Facility, EREC.

The RASPLAV* Project was regarded as a successor to the Three Mile Island Vessel Investigation Project (TMI-VIP) completed in 1993. The TMI-VIP Project was set up t...

Control room, PAKS NPP.

Software-based systems are used and retrofitted in operating nuclear power plants worldwide. The failure modes of both hardware and software in these systems are to some ext...

JAEA  High-temperature Engineering Test Reactor Photo: Japan Atomic Energy Agency (JAEA)

The Committee on the Safety of Nuclear Installations (CSNI) Task Group on Advanced Reactor Experimental Facil...

Post-test view inside OLHF-4 vessel showing penetrations and resolidified weld material at the vessel bottom.

During a severe accident, the lower head of a reactor pressure vessel (RPV) can be subj...

                                                                                  EPICUR facility, IRSN.

STEM phases

First phase (2011-2015)

The STEM Project was initiated with a first phase in 20...

Photo: RBHT Test Facility. US NRC.

Modelling reactor core behaviour under accident conditions with delayed re-introduction of cooling water (commonly referred to as reflood) is a challenge for safety...

Fire protection layer for electrical cables

The Stress Corrosion Cracking and Cable Ageing Project (SCAP) lasted four years (2006-2010). The project’s main objectives were to:

• establish two comple...

View of the RASPLAV-3 Facility.

The Material Scaling (MASCA) Project was a follow-up of the RASPLAV Project and investigated in-vessel phenomena during a severe accident with core melt. Specifica...